Ford Escort Manual

Rear stub axle carrier Saloon and Estate models) - removal and refitting
Suspension and steering / Rear stub axle carrier Saloon and Estate models) - removal and refitting


Removal
1 Raise and support the rear of the car on stands (see УJacking and Vehicle SupportФ).

Remove the roadwheel.

2 Remove the rear hub as described in Section 9.

3 Remove the rear brake shoe assembly, as described in Chapter 9. You will also need to disconnect the brake fluid pipe at its connection to the wheel cylinder. Plug the pipe and cylinder connections to prevent fluid loss and the ingress of dirt.

4 Extract the handbrake cable through the backplate, then unscrew the four backplate retaining bolts and withdraw the backplate.

5 Position a jack under the lower arm and support it.

6 Undo the two nuts and remove the bolts securing the shock absorber to the stub axle carrier (see illustration).

16.6 Rear stub axle and shock absorber attachment - Saloon and Estate models
16.6 Rear stub axle and shock absorber attachment - Saloon and Estate models

7 Undo the nut and remove the lower arm outboard pivot through-bolt.

8 Accurately record the location and number of washers at the tie-bar attachment then undo the nut and withdraw the stub axle carrier.

Refitting
9 If the stub axle is damaged or worn excessively then it must be renewed.

10 Refitting is a reversal of the removal procedure, but note the following: a) When reassembling the tie-bar to the stub axle ensure that the spacers, washers and bushes are correctly located (as noted during removal).

b) Do not fully tighten the suspension retaining nuts and bolts to their specified torque settings until the vehicle is lowered and standing on its roadwheels.

c) Refit and connect the brake assembly components, as given in Chapter 9. Leave bleeding the hydraulic circuit until after the hub and brake drum are refitted.

d) Adjust the hub bearings, as detailed in Section 8.


© 2018 www.fordescortcar.ru. All Rights Reserved.