Ford Escort Manual

Front suspension lower arm (forged type) - removal, overhaul and refitting
Suspension and steering / Front suspension lower arm (forged type) - removal, overhaul and refitting


1 The forged type suspension arm is fitted to all models except pre-May 1983 1.1 litre versions.

Removal
2 Jack up the front of the car and support it on stands (see УJacking and Vehicle SupportФ).

3 Undo the nut and remove the pivot bolt securing the lower arm at its inboard end (see illustration).

3.3 Suspension lower arm disconnected at inboard end
3.3 Suspension lower arm disconnected at inboard end

4 Disconnect the lower arm balljoint from the hub carrier by removing the nut and pinchbolt.

Note that the pinch-bolt is of the socketheaded (Torx) type and a special key or socket bit (available from accessory shops) will be required for this purpose (see illustrations).

3.4a Removing the lower arm balljoint pinch-bolt nut
3.4a Removing the lower arm balljoint pinch-bolt nut

3.4b Separating the balljoint from the hub carrier
3.4b Separating the balljoint from the hub carrier

5 Unscrew and remove the nut, washer and bush from the end of the anti-roll bar as described in Section 5 (or tie-bar on 1985 RS Turbo models) (see illustration). Withdraw the arm from under the car.

3.5 Anti-roll bar-to-lower arm mounting
3.5 Anti-roll bar-to-lower arm mounting

A Nut
B Dished washer
C Bushes
D Lower arm
E Anti-roll bar

Overhaul
6 Renewal of the pivot bush at the inboard end of the arm is possible using a vice and small tubes of suitable diameter (see illustration). Lubricate the new bush thoroughly with rubber grease to ease installation.

3.6 Method of fitting lower arm inboard pivot bush
3.6 Method of fitting lower arm inboard pivot bush

A Tubular spacer
B Lower arm
C Bush
D Tube or
socket
E Vice

7 If the balljoint is worn it will be necessary to renew the arm complete as the balljoint cannot be removed separately.

Refitting
8 Refitting is the reverse sequence to removal. Tighten all nuts and bolts to the specified torque with the weight of the car on its roadwheels. When refitting the Torx pinchbolt, note that the head of the bolt must face the rear of the car.


© 2018 www.fordescortcar.ru. All Rights Reserved.